|
ValiDator II™
|
|
|
|
Will Your Thinlayer Nuclear Gauge Calibration
Guarantee Full Pay?
|
| |
ValiDator II will put your mind at ease. Verify your gauge at any thickness between 1 to 4 inches (2.5 to 10 cm). Select a thickness, place your gauge on ValiDator II and take a reading. Compare the density gauge readings to the NIST traceable density provided with the ValiDator II. Use the PC software, if necessary, to calibrate your gauge. Enter the new parameters into your gauge. You are now ready to start testing with the highest level of accuracy. No more scheduling or weeks of down time. Now you can check your performance against CORES with an Accurate Gauge Calibration.
|
|
|
Features:
|
- Reliable Standard, No Moving Parts
- Portable and Mobile
- Density Gauge Verification from 1 to 4 inches (2.5 to 10 cm) - Densities derived from National Institute of Standards and Technology (NIST) Traceable Reference Blocks
- Accurate Field Three Block Calibration Method for Troxler 4640B and 3450 gauges
- Field and Laboratory Ready
|
Benefits:
|
- Save up to $350 per year per gauge
- Reduce Nuclear Gauge Shipping Formalities
- Check Calibration Quality Daily Within the Density Range of Asphalt
- Minimize Calibration Down Time
- Reduce Gauge Operating Costs
- Resolve Disputes in Gauge Results
- Improve Measurement Quality
- Manage Your Gauge Fleet More Effectively
|
Why Do You Need the Validator II?
|
| |
Thinlayer Nuclear Gauge users have all experienced the sometimes sudden variability in density results. The Thinlayer Nuclear Gauge has a total of five GM counters (4 for 3450) that make up two independent systems within this gauge. The densities measured by each system along with the selected thickness is internally converted to a Thinlayer Density Gauge result on asphalt. During calibration these tubes are in effect synchronized together to produce the necessary Thinlayer Density Gauge results. Due to relatively high counting rates on system 1, and hot test material temperature, there is a tendency for these tubes to go out of synchronization more often than conventional gauges. This phenomena does not necessarily occur at a given period after gauge calibration. It can happen at any time. The ValiDator II is specifically designed to conveniently verify and re-calibrate your gauge at your facility or in the field. Eliminate down time, reduce shipping hassles and improve your measurement performance.
|
|
|
|
|
|
|
